High-speed backstops for internal and external gear reducer mounting, Models FSO, HSB, FS-50, RSCI, and RIZ

•	13 different sizes
•	Bore range: 6 to 508 mm
•	Torque range: 2.1 to 952000 Nm
•	Designed for rebuilding – reducing long-term operation costs
•	Removable torque arm – easier installation
•	Grease labyrinth seals – protect internal components
•	Formchrome sprags – longer wear life
•	Free action retainer – tolerates larger concentricity fl uctuations
•	Full range of options includeing OSHA covers, set collars and restraint keys

CECON units are available with a disconnect feature that provides physical separation of the input and output shafts. This allows maintenance to be performed on the non-energized driver while the disconnect CECON is locked out in the disconnect position.

•	Designed for high-speed, continuous operation
•	View port allows visual confirmation of disconnect/connect status
•	Full-speed testing of isolated equipment prior to reconnection
•	Operates in adverse atmospheres
•	Reduced downtime
•	Long Service Life
•	Minimum maintenance

TB Wood’s offers a full line of sheaves and drives to meet your specific application requirements.

•	Conventional V-Belt drives
•	Narrow drives (Ultra-V)
•	Light-duty drives (FHP)
•	Synchronous Plus drives
•	QT Power Chain® synchronous belt drives

•	Automatic engagement and disengagement
•	Delayed engagement produces a “no load start”
•	No slippage at full running speed
•	Controlled soft-start acceleration
•	100% efficient at rated speed
•	Standard, spring control, and deep pocket models
•	Protection against shock loads during start-up

The flexibility of Wood’s engineering, foundry and machine shop facilities allows us to design and manufacture special non-standard (made to order) sheaves and pulleys to meet a variety of customer requirements. Sheaves and pulleys up to 108 inches O.D., with any face width can be built to customer designs or can be designed by Wood’s experienced engineers to customer specification.

Sure-Grip® “Quick Detachable” bushings are easy to install
and remove. They are split through flange and taper to provide a true clamp on the shaft that is the equivalent of a shrink fit.

•	6-hole drilling (most sizes) makes installation and removal quick and easy.
•	Keyseat 180° from split.
•	Precise taper (3/4 in. per ft. on diameter) provides proper wedging action.
•	Saw cut through flange and taper (and sometimes cut down into keyway also) to provide a true clamp fit.
•	Cap screws used to secure bushings to sheave and to remove bushing from sheave